CCNP Routing Study Guide- P10

CCNP Routing Study Guide- P10:T his book is intended to help you continue on your exciting new path toward obtaining your CCNP and CCIE certification. Before reading this book, it is important to have at least read the Sybex CCNA: Cisco Certified Network Associate Study Guide, Second Edition. You can take the CCNP tests in any order, but you should have passed the CCNA exam before pursuing your CCNP.
Nội dung trích xuất từ tài liệu:
CCNP Routing Study Guide- P10 Hands-on Lab 233 RouterB(config)#router eigrp 100 RouterB(config-router)#network 172.16.0.0 RouterB(config-router)#exit RouterB# 3. Implement EIGRP on RouterC, as shown here: RouterC#conf t Enter configuration commands, one per line. End with CNTL/Z. RouterC(config)#router eigrp 100 RouterC(config-router)#network 172.16.0.0 RouterC(config-router)#network 192.168.1.0 RouterC(config-router)#^Z RouterC# 4. Display the topology table for RouterB, as shown here: RouterB#show ip eigrp topology Codes: P - Passive, A - Active, U - Update, Q - Query, R - Reply, r - Reply status P 172.0.0.0/8, 1 successors, FD is 307200 via 172.16.20.5 (307200/281600), Ethernet0/0 P 192.168.1.0/24, 1 successors, FD is 307200 via 172.16.40.6 (307200/281600), Ethernet0/1 P 172.16.40.4/30, 1 successors, FD is 281600 via Connected, Ethernet0/1 P 172.16.20.4/30, 1 successors, FD is 281600 via Connected, Ethernet0/0 RouterB# Copyright ©2001 SYBEX , Inc., Alameda, CA www.sybex.com 234 Chapter 6 IGRP and EIGRP Review Questions 1. When does EIGRP recalculate its topology table? A. On a synchronized schedule B. When an administrator uses the redirect command C. Automatically every 120 seconds D. Only when there is a change in the network topology 2. The neighbor table uses which of the following timers? (Choose all that apply.) A. SRTT B. RTO C. Hold timer D. FwdDelay timer E. MaxAge timer 3. When there are no feasible successors and only one link to a destina- tion network, even if the link cost is set to 100,000, the link will always be in which of the following modes? A. On B. Standby C. Active D. Sending 4. Which of the following are not routed protocols supported by EIGRP? A. TCP B. IP C. IPX D. AppleTalk Copyright ©2001 SYBEX , Inc., Alameda, CA www.sybex.com Review Questions 235 5. What are benefits of using a link-state routing protocol? (Choose all that apply.) A. It uses the Hello protocol to establish adjacencies. B. It uses several components to calculate the metric of a route. C. Updates are sent only when changes occur in the network. D. It is a better protocol than distance-vector is. 6. Which route type must be redistributed by a routing protocol if other routers are to learn about it? A. RIP B. Default routes C. Connected routes D. Static routes 7. Why are passive interfaces used on interfaces where the router partic- ipates in EIGRP Global mode processes? A. To stop unwanted route information from entering the specified interface B. To allow route information to be filtered by an access list C. To allow routes to be sent out the specified interface, but deny route information to enter the interface D. To allow routes to enter the interface, but deny any route informa- tion to exit the specified interface 8. How is a feasible successor chosen when the successor fails (assuming that a redundant route exists)? (Choose all that apply.) A. The route with the next-lowest metric is chosen. B. If a router doesn’t have a feasible successor, queries are multicast to neighboring routers in search of a feasible successor. C. The route is removed from the routing table. D. The route is flagged as an active state. Copyright ©2001 SYBEX , Inc., Alameda, CA www.sybex.com 236 Chapter 6 IGRP and EIGRP 9. Which command should be used to ensure proper metric conversion when redistributing routes from different protocols? A. distance distance-value B. default-metric C. distribute-list D. default-information 10. How is EIGRP implemented on a router? A. ip router eigrp autonomous-system-number B. router ip eigrp autonomous-system-number C. router eigrp process-id D. router eigrp autonomous-system-number 11. Which of the following are not features of EIGRP? (Choose all that apply.) A. Incremental updates B. Only one route per destination C. Support for IP, IPX, and AT D. Hybrid distance-vector and link-state routing protocol E. Not a scalable protocol ...