CCNP Routing Study Guide- P4

CCNP Routing Study Guide- P4:T his book is intended to help you continue on your exciting new path toward obtaining your CCNP and CCIE certification. Before reading this book, it is important to have at least read the Sybex CCNA: Cisco Certified Network Associate Study Guide, Second Edition. You can take the CCNP tests in any order, but you should have passed the CCNA exam before pursuing your CCNP.
Nội dung trích xuất từ tài liệu:
CCNP Routing Study Guide- P4 Written Lab 53 Written Lab In this lab, write in the routing protocol that is described. The possi- bilities are RIP, RIPv2, IGRP, EIGRP, IS-IS, and OSPF. More than one answer may be possible per characteristic. Protocol Characteristic Maximum of 15 hops by default Administrative distance of 120 Administrative distance of 100 Administrative distance of 90 Administrative distance of 110 Uses composite metric to determine the best path to a remote network Uses only hop count to determine the best path to a remote network VLSM support Non-proprietary Floods network with LSAs to prevent loops Must have hierarchical network design Uses only bandwidth as a metric Uses more than one table to assist in rapid convergence Route update contains only needed information Automatic route summarization at major network boundaries Copyright ©2001 SYBEX , Inc., Alameda, CA www.sybex.com 54 Chapter 2 Routing Principles Review Questions 1. What are two benefits of using a link-state routing protocol? A. It uses the Hello protocol to establish adjacencies. B. It uses several components to calculate the metric of a route. C. Updates are sent only when changes occur in the network. D. It is a better protocol than the distance-vector protocol. 2. Which protocols do not use a topology table? A. EIGRP B. IGRP C. RIPv1 D. OSPF 3. RIPv2 provides which of the following benefits over RIPv1? A. RIPv2 is link-state. B. RIPv2 uses a topology table. C. RIPv2 supports VLSM. D. RIPv2 uses Hello messages. 4. What is the administrative distance of directly connected routes? A. 0 B. 1 C. 90 D. 100 E. 110 Copyright ©2001 SYBEX , Inc., Alameda, CA www.sybex.com Review Questions 55 5. Which of the following are considered distance-vector? (Choose all that apply.) A. RIP B. RIPv2 C. IGRP D. EIGRP E. OSPF F. IS-IS 6. What is the default administrative distance of OSPF? A. 0 B. 1 C. 90 D. 100 E. 110 7. Which is true regarding classless routing? A. It sends periodic subnet mask information. B. It sends incremental subnet mask information. C. It sends prefix mask information. D. All devices on the network must use the same mask. 8. What is the default administrative distance of EIGRP? A. 0 B. 1 C. 90 D. 100 E. 110 Copyright ©2001 SYBEX , Inc., Alameda, CA www.sybex.com 56 Chapter 2 Routing Principles 9. Which is true regarding classful routing? A. It sends periodic subnet mask information. B. It sends incremental subnet mask information. C. It sends prefix mask information. D. All devices on the network must use the same mask. 10. What is the default administrative distance of static routes? A. 0 B. 1 C. 90 D. 100 E. 110 11. Which of the following protocols support VLSM? (Choose all that apply.) A. RIP B. RIPv2 C. IGRP D. EIGRP E. IS-IS F. OSPF 12. What is the default administrative distance of IGRP? A. 0 B. 1 C. 90 D. 100 E. 110 Copyright ©2001 SYBEX , Inc., Alameda, CA www.sybex.com Review Questions 57 13. Which of the following protocols use only hop count to determine the best path to a remote network? (Choose all that apply.) A. RIP B. RIPv2 C. IGRP D. EIGRP E. IS-IS F. OSPF 14. What is the default administrative distance of RIP? ...