Manual Classroom Setup Guide

This course recommends a classroom with one computer for the instructor and one computer for each student. Before class begins, install and configure all of the computers by using the information and instructions in this setup guide. All hardware that is used must be listed on the Hardware Compatibility List (HCL) for Microsoft Windows XP. This course requires Microsoft® Certified Technical Education Center (Microsoft CTEC) hardware level 3 for 2001 for the instructor computer and Microsoft CTEC hardware level 2 for 2001 for the student computers. The current hardware levels are in the Appendix. Microsoft recommends a minimum 256MB RAM for running the Platform Builder Emulator environment....
Nội dung trích xuất từ tài liệu:
Manual Classroom Setup Guide Manual Classroom Setup Guide Course Number: 2530A Part Number: X08-65736 Released: Information in this document, including URL and other Internet Web site references, is subject to change without notice. Unless otherwise noted, the example companies, organizations, products, domain names, e-mail addresses, logos, people, places, and events depicted herein are fictitious, and no association with any real company, organization, product, domain name, e-mail address, logo, person, places or events is intended or should be inferred. Complying with all applicable copyright laws is the responsibility of the user. Without limiting the rights under copyright, no part of this document may be reproduced, stored in or introduced into a retrieval system, or transmitted in any form or by any means (electronic, mechanical, photocopying, recording, or otherwise), or for any purpose, without the express written permission of Microsoft Corporation. Microsoft may have patents, patent applications, trademarks, copyrights, or other intellectual property rights covering subject matter in this document. Except as expressly provided in any written license agreement from Microsoft, the furnishing of this document does not give you any license to these patents, trademarks, copyrights, or other intellectual property.  2001 Microsoft Corporation. All rights reserved. Microsoft, MS-DOS, Windows, Windows NT, Visual Studio are either registered trademarks or trademarks of Microsoft Corporation in the U.S.A. and/or other countries. The names of actual companies and products mentioned herein may be the trademarks of their respective owners. Course Number: 2530A Part Number: X08-65736 Released: Manual Classroom Setup Guide iii Contents Classroom Requirements .........................................................................................1 Classroom Configuration .........................................................................................2 Instructor Computer ...................................................................3 Student Computers...................................................................................................5 Appendix: 2001 Hardware Levels ...........................................................................6 Classroom Requirements This course recommends a classroom with one computer for the instructor and one computer for each student. Before class begins, install and configure all of the computers by using the information and instructions in this setup guide. All hardware that is used must be listed on the Hardware Compatibility List (HCL) for Microsoft Windows XP. This course requires Microsoft® Certified Technical Education Center (Microsoft CTEC) hardware level 3 for 2001 for the instructor computer and Microsoft CTEC hardware level 2 for 2001 for the student computers. The current hardware levels are in the Appendix. Microsoft recommends a minimum 256MB RAM for running the Platform Builder Emulator environment. Software The following table shows all of the software needed to set up the classroom for this course, including the version that was tested with the course and where the software can be found. Software Version tested and notes Microsoft Windows XP - Microsoft Office XP or Microsoft - PowerPoint Viewer Microsoft Windows CE .NET Release version 4.0 Microsoft Embedded Visual Tools for Release version 4.0 C++ Microsoft Visual Studio .NET Must install Smart Device Extensions 2 Error! No text of specified style in document. Classroom Configuration • A training room appropriate in size for the number of trainees. Class sizes should be limited to 12 students. • A data projector suitable for showing PowerPoint presentations. Typically the Instructor Machine will have PowerPoint installed and be connected to the projector. This allows projection of live labs and demos as well as PowerPoint slides accompanying lectures. • A Microsoft Windows TCP/IP Ethernet (not token ring) network with a DHCP server enabled. It is preferred that this network be either isolated completely or at minimum on an isolated subnet. This is to speed downloads by eliminating problems caused by heavy network traffic times and broadcast messages. All lab work for course 2530A will done using the emulator. Therefore, no reference platforms are required. The following configuration and naming conventions are used throughout this course and are required for the hands-on labs: • Instructor1 – is the instructor workstation used for the PowerPoint slides and demonstrations. • StudentX – (Where X is a number 1-12) this is the students’ workstation where they will build and download during labs. Notes/Suggestions • There must also be a ...