Nghệ thuật xếp hình Nhật Bản: RHINO

Nghệ thuật xếp hình Nhật bản: RHINO. Tài liệu rất có ích, nó giúp bạn nâng cao kỹ năng gấp tất cả mọi thứ bằng giấy. Bạn có thể gấp thành thạo những gì bạn thích cho riêng mình và cho bạn bè bạn.
Nội dung trích xuất từ tài liệu:
Nghệ thuật xếp hình Nhật Bản: RHINO Black Rhinoceros c Ronald Koh - 1993 1. 2. A sheet of paper of at least 20 cm square Now fold the lower diagonal edges to meet would be preferred for this model. Fold and along the vertical crease line in the centre. unfold diagonally in half, creasing well. 3. 4. 5. Turn paper over ... ... and fold down the Turn the paper over triangular portion at the again ... top as illustrated. 6. 7.... and unfold the overlapping layer to ... like this. Now fold vertically in half, each side ... from left to right ...8. 9. 10. ... then valley fold along the Separate the two layers Fold and unfold, edge of the white triangular along the horizontal edge Creasing firmly ... portion, crease firmly, and and squash fold. unfold. 11. 12. 13.Do a petal fold by pulling the ... like this. Turn the ... separate the two layersdiagonal edge of the paper over, ... along the diagonaluppermost layer 45 degrees edges on the left anddown and to the left, while squash fold.drawing in the horizontal and 15.vertical edges at the top 16.together ...14. Valley fold the horizontal edge ... then fold done the Fold down both corners at of the white layer to meet the coloured triangular the top, and do a rabbits diagonal edge of the coloured portion in the middle ear fold at the bottom ... layer on each side, ... as illustrated. 17. 18. ... like this. Separate the two layers of the triangular tab and squash fold, ... ... then mountain fold along the existing diagonal crease lines to narrow the upper section before bringing the point at the top to meet the point at the bottom ...19. 20. 21. ... like this. Fold the lower diagonal edges to Fold and unfold again as meet the adjacent diagonal edge illustrated, creasing firmly again. of the kite-shaped flap in the centre, crease firmly, and unfold. 22. 23. 24. Fold the first layer up,... ... then turn the model over. 25. Grasp each side at the circled areas, holding the coloured portions only, then pull apart to open out ... 26. ... like this. Now lift up the the white triangular layer at the top and the second layer at the bottom ... ...