Chapter 5 - CCNP ROUTE

A BGP routing policy has been created using route maps. The command route-map TEST permit 10 is part of the configuration. What does the argument 10 indicate? It identifies the access list number to be used by the route map statement. It identifies the position of the route map in relation to other instances. It indicates the local preference to be set for routes that match the route map. It indicates the metric to be set for routes that match the route map. It specifies the route map to be used on autonomous system 10....
Nội dung trích xuất từ tài liệu:
Chapter 5 - CCNP ROUTE Close Window Assessment System 1. Assessment Selection 2. Assessment Settings 3. Take Assessment Take Assessment - ROUTE Chapter 5 - CCNP ROUTE (Version 6.0) Time Remaining:1 Routing protocol convergence time would be an example of which path control consideration? adaptability availability performance predictability resiliency2 A BGP routing policy has been created using route maps. The command route-map TEST permit 10 is part of the configuration. What does the argument 10 indicate? It identifies the access list number to be used by the route map statement. It identifies the position of the route map in relation to other instances. It indicates the local preference to be set for routes that match the route map. It indicates the metric to be set for routes that match the route map. It specifies the route map to be used on autonomous system 10.3 Refer to the exhibit. What would be the RIP routing metric for the subnets of the 172.16.0.0/16 network on the R2 router after the configuration in the exhibit was applied to the R1 router? 1 2 3 4 54 Refer to the exhibit. The routing policy for router R1 states that traffic from the 192.168.1.0 LAN network is to be routed to ISP-1 and traffic from the 172.16.1.0 LAN network is to be routed to ISP-2. However, the network administrator notices that a host at IP address 172.16.1.10 is being routed out Serial0/0/0. What is the cause of the problem? The route map ISP-1 should be applied to Serial0/0/0. The route map ISP-2 should be applied to FastEthernet0/1. The route maps are applied to opposite interfaces. There is an incorrect access list 1 statement. There is an incorrect access list 2 statement.5 What are three accurate descriptors of the functionality of the Cisco IOS IP SLA feature? (Choose three.) the sending of simulated data applies only to distance vector protocols the filtering of routing updates to and from neighbors a requirement that NTP be configured on source and responder provision of a mechanism to mark packets with different ToS verification that the TCP or UDP ports on a target are active and responsive6 Refer to the exhibit. Based on the information that is presented, which statement is true? Access list 1 specifies that packets with a destination address of 192.168.1.0 will be policy routed. Access list 2 specifies that packets with a source address of 172.16.1.0 will be policy routed. Packets that match access list 1 will be sent to the next-hop address 172.17.1.2. Packets that match access list 2 will be denied access. Both match statements must be true for the ISP1 route map to be true.7 What is the purpose of using an offset list when implementing path control in EIGRP? to measure EIGRP updates and then trap them once they meet a specific threshold to filter EIGRP updates in a continuous, reliable, and predictable manner to increase incoming and outgoing metrics to routes learned by EIGRP to cause the router to evaluate for inconsistencies all packets that come into an interface8 Quality of Service (QoS) and Cisco Wide Area Application Services (WAAS) are two examples of which path control consideration? resiliency availability adaptability performance support for network and application services9 Refer to the exhibit. On the basis of the information presented, which two IP SLA related statements are true? (Choose two.) IP SLA 99 is measuring jitter. IP SLA 99 is scheduled to begin in 2 hours. IP SLA 99 is sending echo requests every 10 seconds. IP SLA 99 is sending echo requests from IP address 192.168.2.1. IP SLA 99 was configured with the type dns target-addr 192.168.2.1 command. IP SLA 99 will run forever unless explicitly disabled.10 Which two descriptions are accurate about the path control functionality of offset lists? (Choose two.) used to increase metrics used to increase administrative distance provides a mechanism to mark packets with ToS can be applied to only the inbound direction on an interface can be applied to routes that are learned via dynamic routing protocols can be applied only to routes that are learned via distance vector protocols11 Which two IP SLA path control statements are true? (Choose two.) An IP SLA operation is a measurement that includes protocol, frequency, traps, and thresholds. IOS IP SLA is a mechanism for increasing incoming and outgoing metrics to routes t ...